General Category > General Discussion

Bike to Bike Jumper Cables

<< < (4/4)

Kiwi_Roy:
As Wayne did you can make some serious jumper cables out of speaker wire and 4 clips, you could crank a truck through that except the bike battery may not have enough CCA. It would transfer enough energy for the truck battery to do it's own cranking after a few minutes with the bike running.
My idea was to use some wiring that the bike already has and simply plug two bikes together using a scrap of 2 core cable from an appliance to transfer some charge from one to the other as I mentioned several times already I don't need to crank the flat bike just give it a substantial charge rate until the bikes battery can do the work. this could be done quite discretely without removing plastic to uncover the battery.
If nothing else the topic has made a few people aware they should be prepared.
 

Navigation

[0] Message Index

[*] Previous page