Author Topic: Peg Nut Replacement?- Crank & G/Box Input Hub  (Read 306 times)

Offline 1down5up

  • Weekend Warrior
  • ***
  • *
  • *
  • Posts: 133
  • Location: Sydney NSW Australia
Peg Nut Replacement?- Crank & G/Box Input Hub
« on: June 13, 2019, 09:36:41 PM »
Hi All,

I recall reading somewhere that there are standard "hex" replacements for the Crank & G/Box Hub peg nuts for tonti's (t3/lemans etc), i have searched but haven't been able to find any older posts.

Believe they may have been used on later guzzi's (v11's etc)?

Does anyone have a part number for these replacements, and do they still use the tab lock washer?

Online Antietam Classic Cycle

  • Guzzi Hero
  • *****
  • *
  • *
  • Posts: 12061
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Charlie
http://www.AntietamClassicCycle.com
'69 V700
'69 Ambassador
'71 Ambassador
'73 Eldorado
'74 850-T
'76 Convert
'77 Morini 3 1/2 Strada
'81 Ducati 500SL Pantah
'82 V50 III

Offline 1down5up

  • Weekend Warrior
  • ***
  • *
  • *
  • Posts: 133
  • Location: Sydney NSW Australia
Re: Peg Nut Replacement?- Crank & G/Box Input Hub
« Reply #2 on: June 14, 2019, 04:53:23 PM »
Many thanks, now to see if I can find a long enough socket for the crank nose


Crank nut: http://www.mgcycle.com/index.php?main_page=product_info&cPath=68_126&products_id=1451
Washer used with it: http://www.mgcycle.com/index.php?main_page=product_info&cPath=68_126&products_id=1505

For the input shaft of the 5 spd. I use an output shaft nut with the "lip" ground off, secured with threaded locker.
http://www.mgcycle.com/index.php?main_page=product_info&cPath=55&products_id=507

 

20 Ounce Stainless Steel Double Insulated Tumbler with donation credit
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here