New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
I just got back from a two week trip and I wanted to check in on this topic. During my trip I think I lost the side stand bold that is recessed in to the large hole. I was able to secure the upper bolt with a ball headed hex wrench I could slide in over the header. I wonder if anyone has managed to replaced the lower without removing the header and the related plastic. It doesn't look possible, but I thought I'd check to see if anyone had any tricks up their sleeve. Thanks.
Loctite has a thread retaining fluid that will wick down the threads so there is no need to undo the bolt. I can't remember the number but it is very thin. You only need to get it to the thread join.
Side stand on my 2011 was really loose. Removed the header, applied red to both of the bolts, and tightened them down. The stand now hits the bottom of the foot peg. Any thoughts?
Page created in 0.024 seconds with 22 queries.