New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
Notice the additional non-factory brazing around the center mounting boss, at the juncture between the ~2-in diameter boss and the flywheel pan. This is what I did on my '77 Convert, in an effort to still use the lighter failure-prone flywheel. People said you could feel the difference between the lighter flywheel and one of the heavier later versions, but I couldn't. It is really amazing that MG let the lighter flywheels leave the factory without this critical reinforcement. Seems to me it would have been MUCH cheaper production-wise to just add this bit of reinforcement, rather than commit to machined-aluminum flywheels.
Bruce, stick with the Rotella T
That's what I use. Now called T4. Tried Valvoline VR-1 20w50 and my mpg dropped by 3! Back to Rotella this change.
Someone mentioned losing 3mpg with a fluid switch. That's a good indication of slipping.
Well I took the convert out with a couple of riders to to a cool shop about 45 miles away with speeds up to 70mph and everything seemed great, marked it's spot at the shop with a drop from the breather tube and on the way back at about 15 miles it started slowing down like it wasn't getting gas, kept playing with it to another shop and pulled the plugs and they looked pretty good, so went ahead and change them with new and took off, the last 30 miles it would not run above 50if I gave it any more throttle then off idle and then ever once in awhile it would run up to 70 and then start all over again like it was not getting fuel, so I went through town at slower speeds and limped her home. Back to the drawing board.Bruce
1st round, I pulled the right side while sitting on the bike fuel line and measured about 6 ounces in 15 seconds with a stop watch then went to the left side and measured a hair over 5 ounces in 15 seconds, there was no water or debris in the gas that I could see after letting each time sit for about 3 minutes, so I'm not sure if the petcock screens have debris on them, seemed to me to flow pretty good to me, what do you folks think? I think I'm going to take it out and see if I can replicate the problem and then do the flow test again if it acts up again, I've run the bike for 220 miles so far with only the last 30 with the problem of not being able to get fuel, that feeling anyway, plus when I take it out again and burn more fuel off it will help if I have to remove the tank, who thought that about 6 gallons in a tank could weigh so much Bruce
Page created in 0.035 seconds with 24 queries.