Wildguzzi.com

General Category => General Discussion => Topic started by: Steve350f on April 26, 2019, 12:34:14 PM

Title: Bar end turn signals Eldo 1400
Post by: Steve350f on April 26, 2019, 12:34:14 PM

I'm considering getting the Moto Gadget bar end signals for my Eldo 1400.  Are the threaded plugs in the Eldo bars that hold the current end weights removable?  Didn't want to mess with them too much and jack them up.  Thanks 

Title: Re: Bar end turn signals Eldo 1400
Post by: Zoom Zoom on April 27, 2019, 05:40:59 AM

Looks like you may be blazing a new trail, much like the shield you brought up. I don't know the answer, but at least your thread will be bumped up.

John Henry

Title: Re: Bar end turn signals Eldo 1400
Post by: Steve350f on April 27, 2019, 01:12:31 PM

Quote from: Zoom Zoom on April 27, 2019, 05:40:59 AM

Looks like you may be blazing a new trail, much like the shield you brought up. I don't know the answer, but at least your thread will be bumped up.

John Henry

Ya, blazing the trail can get expensive tho.  Ha ha 

Title: Re: Bar end turn signals Eldo 1400
Post by: Daleroso on April 27, 2019, 03:41:00 PM

If they have the 8 sided outer that you can get a crescent wrench on they were no problem to remove off a V7III. I then installed 2 CRG 7/8" lane splitter mirrors.

Title: Re: Bar end turn signals Eldo 1400
Post by: Tom on April 28, 2019, 03:43:37 PM

How much wider would that make your bike?

Title: Re: Bar end turn signals Eldo 1400
Post by: Steve350f on April 28, 2019, 09:52:36 PM

Quote from: Tom on April 28, 2019, 03:43:37 PM

How much wider would that make your bike?

None, they are no wider than the stock units.
https://www.revzilla.com/motorcycle/motogadget-m-blaze-disc-bar-end-led-turn-signal

These are in addition to the existing front turn signals, not to replace.

Still waiting on an answer on how to remove the existing plug if anyone knows.