Wildguzzi.com

General Category => General Discussion => Topic started by: Diploman on May 12, 2019, 05:54:41 PM

Title: Rotor Glaze
Post by: Diploman on May 12, 2019, 05:54:41 PM

Hi All,

I would like to know your recommended method/technique for removing glaze from a brake rotor.  Thanks.

Title: Re: Rotor Glaze
Post by: RinkRat II on May 12, 2019, 07:00:18 PM

 I've used a 90 degree air grinder with Scotch Roloc pads 120 grit or finer with good success.  I've also chucked in my lathe jusy to rotate them while deglazing.

     Paul B :boozing:

Title: Re: Rotor Glaze
Post by: Wayne Orwig on May 12, 2019, 08:22:21 PM

Quote from: RinkRat II on May 12, 2019, 07:00:18 PM

I've used a 90 degree air grinder with Scotch Roloc pads 120 grit or finer with good success. 

This is what I use for brake rotors and clutch flywheels. With a light grit it is great for removing gasket material.