Wildguzzi.com

General Category => General Discussion => Topic started by: nbags on August 19, 2019, 09:39:01 AM

Title: spanner wrench
Post by: nbags on August 19, 2019, 09:39:01 AM

is there a factory spanner wrench to adjust rear shock on quota or an aftermarket wrench out there that works well that. thanks for any suggestions.

Title: Re: spanner wrench
Post by: Tom H on August 19, 2019, 10:19:12 AM

Maybe something like this?

https://www.ebay.com/itm/Progressive-Suspension-SW-783-Pre-Load-Spanner-Wrench/163290161702

Tom

Title: Re: spanner wrench
Post by: Sasquatch Jim on August 20, 2019, 09:05:02 AM

I like the model that hooks around.  Being cheap like most Guzzista I would buy only one and just turn it over to
make it worth other way.  No need to buy both left and right models.

Title: Re: spanner wrench
Post by: yogidozer on August 20, 2019, 09:13:32 AM

Quote from: Sasquatch Jim on August 20, 2019, 09:05:02 AM

I like the model that hooks around.  Being cheap like most Guzzista I would buy only one and just turn it over to
make it worth other way.  No need to buy both left and right models.

Like this, Bigfoot?  :grin:
https://www.ebay.com/itm/2pcs-Motorcycle-Snowmobile-Shock-Absorber-Pre-Load-Spanner-Wrench-Tool-Universal/382456982888?epid=933702923&hash=item590c366d68:g:5~sAAOSwQHpa8U1o

(https://i.ibb.co/92sj4zr/s-l1600.jpg) (https://ibb.co/92sj4zr)

Title: Re: spanner wrench
Post by: nbags on August 20, 2019, 11:14:23 AM

i have a few spanner wrenches but they dont fit very well and it;s kind of hard to turn lock nut .

Title: Re: spanner wrench
Post by: Kiwi_Roy on August 20, 2019, 11:45:21 AM

Just get a scrap of 1/8" aluminium plate and cut one out with a coping saw, 20 minutes top.
I also carve out the other large spanners on the bike such as wheel nuts that way you can make them small enough to fit in the toolkit.