Wildguzzi.com
General Category => General Discussion => Topic started by: ozarquebus on August 29, 2019, 11:30:21 PM
-
I have a 78 Convert parts bike and I was thinking of putting that rear end on a G5 to achieve a higher gear ratio.
Is this a doable plan?
I do not know if it will even fit and do not know if what the Convert ratio is, but I think it will be higher.
-
The stock G5 gearing is 7/33 which works out to a 4.714 to 1 ratio. The Convert gears are 9/34 which works out to a 3.777 to 1 ratio. Quite a bit higher, so much so that I doubt it will work well. It would be like taking off from a standing start in 2nd or 3rd gear.
Then there's the incompatibility in the splines: G5 input is 10 splines, the Convert is 20 splines. That could be solved with this driveshaft:
http://www.mgcycle.com/index.php?main_page=product_info&cPath=35&products_id=5298
If you want higher gearing on the G5, an 8/33 rear drive from a Cal 1100/EV series would be a more workable solution. That ratio is 4.125 to 1, so a usable amount "taller" than the stock 7/33 without going overboard.
-
I have a 78 Convert parts bike and I was thinking of putting that rear end on a G5 to achieve a higher gear ratio.
Is this a doable plan?
I do not know if it will even fit and do not know if what the Convert ratio is, but I think it will be higher.
If you want to swap the 7/33 for an 8/33 I'd be happy to do it as I need a 7/33 for my outfit.
Having said that I would counsel against it as I experimented with various ratios back in the 80's on both a stock SP and various hot-rods and always came back to the 7/33 as the best option.
Pete
-
Thanks for the input, that pretty well sums it up right there, from the sound of it.
Since the rear end on hand would not work, then I doubt I will try to find an alternative just for experimentation.
Thanks
-
Didn’t they call em moon gears? Not practical for most applications...