Wildguzzi.com

General Category => General Discussion => Topic started by: Pescatore on September 15, 2019, 12:25:45 AM

Title: Saprisa alternator screws torque setting?
Post by: Pescatore on September 15, 2019, 12:25:45 AM

Does anyone know the torque setting for the three screws that hold the alternator cover?
I would like to remove it and replace the fiberglass sleeve for the alternator output wires.
I found a similar replacement:https://www.amazon.com/gp/product/B07RLS2G77/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1 (https://www.amazon.com/gp/product/B07RLS2G77/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1)

(https://i.ibb.co/5sv84pj/Alternator.jpg) (https://ibb.co/5sv84pj)


Thanks,
Pescatore

Title: Re: Saprisa alternator screws torque setting?
Post by: nc43bsa on September 15, 2019, 02:42:11 AM

As tight as you can, using a 1/4" drive nutdriver handle and one hand.   :grin:

Unless you're a professional arm wrestler.

Not terribly critical.

Title: Re: Saprisa alternator screws torque setting?
Post by: Pescatore on September 15, 2019, 11:19:54 AM

Thanks.  I'll chug some wheaties first.