Wildguzzi.com

General Category => General Discussion => Topic started by: guzzimaster on December 31, 2019, 06:17:48 PM

Title: Install grip heatrz on V85tt ??
Post by: guzzimaster on December 31, 2019, 06:17:48 PM

I've been searching for help/advice on the installation of Oxford grip heaterz on the V85tt.  I've only read about possible problems from the RBW, no report on making it happen or how to do it.  Can't find any discussion on the install?  Has anyone done aftermarket heaters using the supplied grip heater wire connection on the V85tt?   :weiner:

Title: Re: Install grip heatrz on V85tt ??
Post by: 89MilleGt on December 31, 2019, 11:34:33 PM

I installed Oxford grips on my V85tt, and connected them to the stock wiring so that can use the button on the left controls. They have worked great so far

I wrote up the steps on the V85tt Facebook group site Borja Ruiz Martínez I replied in this post ...

https://www.facebook.com/groups/GuzziV85/permalink/747809662365147/

Basic steps:
Remove grips
Sand throttle tube so grip will fit
Glue on Oxford grips.
V85tt pre-wired connectors are under right side black cover under tank
Lift tank to remove (after removing screws)
Connectors are molex .062
Need to make a cable to connect wires to Oxford controller to V85tt wiring. (Need to cut off Oxford controller.
That’s it. Test and stuff wires back under black cover

Title: Re: Install grip heatrz on V85tt ??
Post by: guzzimaster on January 02, 2020, 12:45:09 PM

Thanks very much for your reply & link to the install process. :bow: