Wildguzzi.com

General Category => General Discussion => Topic started by: Mayor_of_BBQ on May 12, 2021, 07:45:57 AM

Title: Loop generator mount/alt bracket & studs vs. bolts
Post by: Mayor_of_BBQ on May 12, 2021, 07:45:57 AM

I have long heard that you should replace the studs for generator mount with regular bolts.  I have a simple and probably dumb question about this...  Does this also apply to an alternator conversion (specifically the scrambler cycle kit)?

I'm sure bolts are probably better in either case, but I don't know if there are differences in the belt tension or other factors that come into play.


So the question: Should bikes with an alternator conversion be switched off studs to bolts, or does that only apply to bikes running stock generator & bracket?

Title: Re: Loop generator mount/alt bracket & studs vs. bolts
Post by: Don G on May 12, 2021, 08:57:26 AM

You have that backasswards! Replace the bolts with shouldered studs in all cases. DonG

Title: Re: Loop generator mount/alt bracket & studs vs. bolts
Post by: Antietam Classic Cycle on May 12, 2021, 09:00:06 AM

Yes, even if using an alternator kit, hardened studs should replace the original bolts. I use large o.d., thick, flat washers and nylock nuts on the studs.

Title: Re: Loop generator mount/alt bracket & studs vs. bolts
Post by: Mayor_of_BBQ on May 12, 2021, 10:51:49 AM

Ok I am perfect then! I have hardened studs, big washers, and nylock nuts

Thanks guys