Wildguzzi.com

General Category => General Discussion => Topic started by: raul on July 25, 2021, 01:25:15 PM

Title: That ball bearing behind the front brake switch
Post by: raul on July 25, 2021, 01:25:15 PM

Does anyone know the diameter of the little ball bearing under the brake switch at the front brake lever of a 97 California? The little devil decided to go on a roll about while I was changing the brake switch.  A bb is too small. 

Title: Re: That ball bearing behind the front brake switch
Post by: Rolf Halvorsen on July 25, 2021, 01:44:23 PM

Part No: 92295708           Ø3/16" which is about Ø4,76mm.
Rolf

Title: Re: That ball bearing behind the front brake switch
Post by: raul on July 25, 2021, 04:54:47 PM

Thank you.  I'll see if I can find one tomorrow.

Title: Re: That ball bearing behind the front brake switch
Post by: LowRyter on July 25, 2021, 05:45:27 PM

Ace Hardware. 

Title: Re: That ball bearing behind the front brake switch
Post by: nc43bsa on July 25, 2021, 10:31:28 PM

I lost mine last year when was investigating why the switch didn't work on my MilleGT.  I ordered several of them the next time I called MG Cycle.

Now that I have spares, I'll eventually find the original ball on the garage floor.

Title: Re: That ball bearing behind the front brake switch
Post by: raul on July 26, 2021, 09:38:16 AM

I ordered a bag of them from Amazon.  100 stainless steel balls for $5.99.  They will be here Wednesday.  Now that I'll have plenty, I'll never lose another one again.   :laugh: