Wildguzzi.com

General Category => General Discussion => Topic started by: fotoguzzi on September 13, 2021, 03:55:43 PM

Title: Was someone looking for a 6x32 RD?
Post by: fotoguzzi on September 13, 2021, 03:55:43 PM

I guess this from a Convert? Has 20 tooth spline.. might be junk because the pinion has two bad teeth, ring gear looks fine. Not sure if anything can be done to repair it..
(https://i.ibb.co/C8bjTFY/DC832705-4743-4124-A88-A-C59338567-D0-F.jpg) (https://ibb.co/C8bjTFY)

(https://i.ibb.co/PxmvhyW/EDD31689-F909-4417-B307-DD8288-EBA6-A2.jpg) (https://ibb.co/PxmvhyW)

(https://i.ibb.co/fGpQkxm/C47-A657-F-46-CA-4226-9350-527-A49-CED949.jpg) (https://ibb.co/fGpQkxm)
but just uncovered it so putting it out there in case.

Title: Re: Was someone looking for a 6x32 RD?
Post by: guzzisteve on September 13, 2021, 04:22:42 PM

Those didn't come on converts but on 90 Cali's or around there w/full fairing or on some of them. They made a shaft coupler that had small splines on 1/2 and 5 sp splines on 1/2. All these are in the back of a LM2 service manual. Some bought 6/32 for sidecar work but was kinda short gearing.

Title: Re: Was someone looking for a 6x32 RD?
Post by: Don G on September 14, 2021, 08:57:35 AM

Boat anchor!  DonG

Title: Re: Was someone looking for a 6x32 RD?
Post by: fotoguzzi on September 14, 2021, 09:43:20 AM

Well we have boats here in MN.