Wildguzzi.com
General Category => General Discussion => Topic started by: moto on September 22, 2021, 02:16:28 PM
-
Here is an unbranded version of the PHBH 30BS carburetor, suitable, perhaps, for converting from the VHB 30 C's on your T3, etc. Only $80, or $74.40 each if you buy two! It appears to have jets of some sort! Free shipping, from you-know-where.
https://tinyurl.com/xadcac6h (https://tinyurl.com/xadcac6h)
By comparison, Stein-Dinse offer a complete VHB conversion kit based on two Dellorto-branded PHBH 30BS carburetors, with fixin's, for 239 Euros, plus shipping. This has been discussed here recently. I wouldn't be surprised if the two versions differ only in the presence of the Dellorto stamp.
Feeling lucky?
Moto
-
For context, see thread on fake Mikuni jets:
https://wildguzzi.com/forum/index.php?topic=112392.0
-
For context, see thread on fake Mikuni jets:
https://wildguzzi.com/forum/index.php?topic=112392.0
Yep, you get what you pay for, I don't think I would be spending my $$$ on these.
-
Maybe the Chinese floats are actually better? :grin:
-
Or the white floats are actually made in China? :evil:
-
We played the fix-a-jet game with one of those china $23 new fake mikuni carbs. After A long session in the machine shop to carefully remove the junk jet and install a real mikuni jet, it's a good carb for a bike that isn't ridden. I wouldn't expect a china fake Dellorto to be any better.
-
Something about the cheap man pays twice.
-
All this illustrates why I refuse to install any safety-critical parts made in Mainland China on any vehicle I own.
I remember trying to install Chinese brake drums on a Ford. They were out-of-round when I removed them from the box they were sold in.
-
Me, I'm keeping my VHB's. Nearly immortal, as far as I can tell. I've had my own surprises with jets lately.
Moto
-
I'm running $30 PWK 34mm's on my 850T and they work great. I'm not sure why people equate being overcharged with quality.
-
I'm running $30 PWK 34mm's on my 850T and they work great. I'm not sure why people equate being overcharged with quality.
Where did you source them? I've seen some on Amazon. https://www.amazon.com/gp/product/B073SSH8BH
-
i run a set of chinese 34VM mikuni's on my lario,
cost peanuts, they work absolutely great.
the best single improvement on the bike
-
Where did you source them? I've seen some on Amazon. https://www.amazon.com/gp/product/B073SSH8BH
I bought these (currently out of stock)-
https://www.amazon.com/gp/product/B083K7Z6K7/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1
Two left here-
https://www.amazon.com/gp/product/B01L8NN6WG?ref=ppx_pt2_dt_b_prod_image
Either use the rubber manifold boot that comes with it (you'll have to enlarge the engine side) or buy two of these-
https://www.casalambretta.us/index.php?route=product/product&product_id=111&search=%09J200052