Wildguzzi.com
General Category => General Discussion => Topic started by: Deno on September 22, 2021, 06:05:57 PM
-
I am heading out to look at a 2008 Norge next week and was looking for advice on what to check out. I had a 4V Norge but that is another story.
The bike has roughly 30k miles and looks pretty good in pictures.
The current owner bought it a year ago and has decided that it isn’t the bike for him. He rides a BMW GS.
He said the saddle bags are a bit warped and there are minor cosmetic blemishes. The windshield is slow to go up and needs some assist.
It is stock other than a mistral muffler which he stated is a little loud and that the exhaust pops on deceleration.
The battery was replaced by him which means it is less than a year old. He also said the PO had the bike maintained by a dealer
That’s pretty much all I know. Any advice would be appreciated.
-
I am heading out to look at a 2008 Norge next week and was looking for advice on what to check out. I had a 4V Norge but that is another story.
The bike has roughly 30k miles and looks pretty good in pictures.
The current owner bought it a year ago and has decided that it isn’t the bike for him. He rides a BMW GS.
He said the saddle bags are a bit warped and there are minor cosmetic blemishes. The windshield is slow to go up and needs some assist.
It is stock other than a mistral muffler which he stated is a little loud and that the exhaust pops on deceleration.
The battery was replaced by him which means it is less than a year old. He also said the PO had the bike maintained by a dealer
That’s pretty much all I know. Any advice would be appreciated.
If you have a decent long ride, you won’t have to look for much, any issues will present themselves.
Unless it’s been totally neglected, it should feel just fine. Make sure your muscle memory is not still in 8V mode, I used to think the difference was minor, but I accept that the 2VPC is not as free revving above 4,000 rpm, there really is a vast difference.
But you won’t have tappet issues and if you get a Beetle map PROPERLY installed, you’ll be utterly amazed.
If you go ahead and get it though, here are a couple of things.
Mine is an ‘07 very close to 200,000 k
The standard things to do are...
Do the startus interruptus mod..(there’s heaps on that here)
The screen motors were a bit weak from the factory, I had mine replaced under warranty but you can get to the mechanism pretty easily and throw some grease around on the worm drive.
Speaking of grease..
Do not delay and pull the drive shaft out and drop the swingarm down. This is to check for grease or lack of in the pivot races and driveshaft splines, MG are notorious for not greasing them at the factory. There is a piddly little “seal” that is supposed to stop water and contaminant ingress into the space and these seals are usually dislodged on assembly, especially the Right hand (rear brake) side. I have remedied that issue.
The case lids are a bit frail and I did this
(https://i.ibb.co/tsnjcHN/2209-C0-F1-2467-4-C44-8798-3277-AD720-BE6.png) (https://ibb.co/tsnjcHN)
upload image (https://imgbb.com/)
it pulls the lid closed properly.
The popping on deceleration can be air leaks around the exhaust joins but also a good TB balance and TPS reset will help enormously.
Beetle’s map for the 2VPC is fabulous, don’t buggerise around with crappy pretenders, just do it.
Check the tappets, change ALL the fluids and go for a long ride.
Ask as many questions as you like.
-
Take a look at this thread:
https://wildguzzi.com/forum/index.php?topic=87203.0 (https://wildguzzi.com/forum/index.php?topic=87203.0)
In addition to my modest contribution, there's a bunch of other useful info on the various Norge attributes and flaws (I mean, character elements :cool: )
-
Thanks Gents. This will help me ask questions and with the visual.
-
Let’s know if you end up with the Norge Deno.
One thing of extreme importance, is to check the locking security of the pinion retaining nut in the bevelbox. It’ll be easy when you pull the drive shaft for greasing.
If the pinion dumps it’s preload due to the nut undoing...
This happens.
(https://i.ibb.co/kqPkPgp/5-F976542-FFEF-4-B21-92-BD-95-B23-CD300-C1.png) (https://ibb.co/kqPkPgp)
(https://i.ibb.co/h2VjkmK/E1-C29-DE3-9317-43-F7-B687-E970-A964-AD07.png) (https://ibb.co/h2VjkmK)
They are unrepairable, unless you live near Pete Roper and Michael.
Once it’s locked properly, you’ll have no dramas.
-
Sent you a PM.
-
I think I replied. Never can tell with electrons.
-
What’s the asking price and location?
-
It was in or near Rhode Island. Someone got a great deal. I exchanged emails with the seller a few times and was going to offer him 2 grand but he told me it was sold.
-
That bike was a good deal. There is another 2008 for 4k$ in RI as well. I spoke with the owner who honestly described the bike.
In the mean time I bought a 2014 Norge locally. It is Hamlin maintained with upgrades. I should be able to get it through CT DMV next week. That was the earliest appointment I could get.