Wildguzzi.com
General Category => General Discussion => Topic started by: 2slow on May 09, 2022, 06:38:54 PM
-
does anybody know where you can get the 2 plastic insulators for a 72 Ambassador I'm looking for the one inside the distributor that the points spring rests on and the outside round one thanks
-
I’m thinking they are like hen’s teeth - sorry no help but standing by…..
Mark
-
https://www.harpermoto.com/block-12715428.html
They may have the other one (12715427 Insulating plate) as well, but when I clicked on the part number all I got was a 404 error page.
-
Make one, I keep an old cutting board for projects like that
High-density polyethylene, its easy to cut into shape and not brittle.
Drill the hole first then carve out the shape with a utility knife or coping saw.
-
IIRR, one of the insulators has a nipple that goes into the dist. body to insulate the screw. They are not just flat strips bent to fit the dist.. You could make it, just not as easy as two flat strips.
Tom
-
IIRR, one of the insulators has a nipple that goes into the dist. body to insulate the screw. They are not just flat strips bent to fit the dist.. You could make it, just not as easy as two flat strips.
Tom
:thumb: The outer piece could be whittled out of nylon rod, if one had lots of time on their hands.
-
Think new technology. Someone out there should be able to design a program for 3D printing of each piece. Once the design coding is in place, anyone with a 3D printer should be able to pump out a stack of these. Do we have any 3D geeks on this board?
Patrick Hayes
Fremont CA
-
You may be surprised what Ace hardware has in their hardware bins. Look for plastic screw insulators or washers My$.02
Paul B :boozing:
-
What's the demand for this part?
'cuz we're fit'n to pour nylon, probably in 6 months or so. If I had a mould, these could be done on the side with the leftovers.
3D printing would truly be the easy answer if someone has the skill to pattern the part.
-
I thought I'd resurrect this thread to see if anybody found any in an old box or found a new resource for part # 12715427, the outer insulating piece. Otherwise I'll probably go to Ace to see what kind of plastic bits or cheap cutting board they might have.
-
Dont know what this part looks like, but if someone would post a picture and some dimensions, I will assess if it is a part suitable for printing, and print a batch if so. I would need a full dimensional definition of the geometry.
-
I have an inner half coming from Harpers. I'll send it to you when it arrives. I don't have the other half, so I can't provide any dimensions for that.
-
Always check ThisOldTractor.com when looking for something! :grin: :grin:
https://www.thisoldtractor.com/moto_guzzi_loopframe_distributor_condenser_wire_bolt_insulator.html
Both pieces available here for $9: https://mrfiat.com/fiat-500-n-d-f-l-giardiniera-distributor-insulating-plates-kit.html
-
Stupid me. I only searched by Guzzi part numbers.
Thanks Charlie. You saved me from having to whittle away at a nylon rod. :grin:
-
Looks printable, but at a challenging small scale for most printers. At the price, I would recommend purchasing
-
Agreed. Good thought though