Wildguzzi.com

General Category => General Discussion => Topic started by: Denver1000s on September 30, 2023, 04:34:15 PM

Title: Need Parts for 91 1000s
Post by: Denver1000s on September 30, 2023, 04:34:15 PM: Hello All
My rear turn signal bracket and license holder broke. Part # 14 46 84 70. Does any have a spare or knows where online that may have the part. I have already looked on Harpers, MG Cycle and Stein Dinse.
Any advice would be appreciated.
Thank you
Title: Re: Need Parts for 91 1000s
Post by: guzzisteve on September 30, 2023, 04:42:45 PM: Try TLM in Netherlands, I'll bet none out there.
This one-?

(https://i.ibb.co/y5hZfSX/1000-S-tail.jpg) (https://ibb.co/y5hZfSX)
Title: Re: Need Parts for 91 1000s
Post by: Dave Swanson on September 30, 2023, 04:43:12 PM: I would call Harpers, and Moto Guzzi Classics. Harpers still has LOADS more parts than what they show on line. For harder to find oddball stuff it is still best to call.
Title: Re: Need Parts for 91 1000s
Post by: Antietam Classic Cycle on September 30, 2023, 06:47:39 PM: My friend Steve Harry in Vermont may have it, I've Messaged him to see.

It looks like a simple flat steel "C" shaped bracket. If I couldn't find an original, I'd make one out of stainless steel flat stock.
Title: Re: Need Parts for 91 1000s
Post by: blackcat on October 01, 2023, 07:31:45 AM: Quote from: Antietam Classic Cycle on September 30, 2023, 06:47:39 PM

It looks like a simple flat steel "C" shaped bracket. If I couldn't find an original, I'd make one out of stainless steel flat stock.

It’s not just a C shaped bracket as it has a square plate welded to the bottom of the bracket with four holes to accept the license plate bracket. I had the same thing happen to my bike, the whole thing broke off and I unknowingly lost it on a long ride. Fortunately I had an extra bracket and license plate but not the plastic piece. Thanks to you and Steve I acquired that part.

But I’m sure that a good welder could fabricate that part and have it chrome plated as I believe that is what the factory did but I could be wrong. The license plate is similar to other Guzzi models as I have one of those on the shelf, just in case.
Title: Re: Need Parts for 91 1000s
Post by: Denver1000s on October 01, 2023, 08:41:34 AM: Thanks
I looked at TLM too and they list it as out of stock. I'll try calling Harpers tomorrow but online it said pre order. Yes the bracket for the license plate is what broke. Not sure if it could be welded.
Title: Re: Need Parts for 91 1000s
Post by: blackcat on October 01, 2023, 09:12:27 AM: I’d bring it to a welder and see if they can fix it, then get it plated.