Wildguzzi.com

General Category => General Discussion => Topic started by: Mor on October 09, 2024, 08:39:52 AM

Title: Eldorado problems
Post by: Mor on October 09, 2024, 08:39:52 AM

Thanks

Title: Re: Eldorado problems
Post by: guzzisteve on October 09, 2024, 01:30:52 PM

Might be getting air up the threads of the bolt stuck in the line, remove line & cap the spigot. All I got, sounds like air getting in.
Clean throttle body w/cleaner that's OK for the sensor. Oil will goo things up.

Title: Re: Eldorado problems
Post by: kingoffleece on October 10, 2024, 09:19:21 AM

Correct.  Valves can cause that.

Title: Re: Eldorado problems
Post by: guzzisteve on October 10, 2024, 09:29:42 AM

How about the bolt in LH manifold, they should both be capped off w/bolt. I clean my throttle bodies on the EV 1100 every 10Kmi same time I clean the K&n air filter.

Title: Re: Eldorado problems
Post by: moto-uno on October 10, 2024, 07:57:23 PM

  The correct oil level on those models was no more than half way between low and full .
   And I always found that spraying WD-40 around intake sealing areas would high light any intake leaks .
   Boy did I ever enjoy the motor on my 2018 Eldorado.

Title: Re: Eldorado problems
Post by: Moparnut72 on October 11, 2024, 09:37:40 AM

Yes Peter, I really like the motor in my Audace. Too bad I could no longer ride it. The motor in my V100 is very similar, lots of low end power and plenty of scoot up top.
kk