Wildguzzi.com

General Category => General Discussion => Topic started by: Turin on January 25, 2025, 02:37:26 PM

Title: Square head Oil Vent Part # (helped!)
Post by: Turin on January 25, 2025, 02:37:26 PM

I'm almost done building a motor base on a lemans 1000. A lot of parts including a set of bare heads were purchased on E-bay. I've acquired all the obvious stuff. What I'm missing is the oil vent return nipples that screw into the head. Any one know of a part #, an aftermarket replacement, hardware store substitute or, even better have a pair laying around?
Thank You!
See pictures.

(https://i.ibb.co/FJP979K/guzzi-oil-vent.jpg) (https://ibb.co/FJP979K)


(https://i.ibb.co/6sbvvDc/20250124-221037.jpg) (https://ibb.co/6sbvvDc)

Title: Re: Square head Oil Vent Part # Help!
Post by: Antietam Classic Cycle on January 25, 2025, 03:55:02 PM

Part no. 28153960


(https://i.ibb.co/7X0QH5D/28153960-k.jpg) (https://ibb.co/7X0QH5D)


What diameter is the hole - M8 or M10? I may have some from a V7 Sport, but they're M8.

Looks very similar to the vent fitting on 5 spds., before it was moved to the rear cover.
 

Title: Re: Square head Oil Vent Part # Help!
Post by: Turin on January 25, 2025, 04:10:51 PM

Thank you!!!! Pretty sure they are M10.

Update - found via E-bay Italia! Thank you Charles !

Title: Re: Square head Oil Vent Part # Help!
Post by: Antietam Classic Cycle on January 25, 2025, 05:30:06 PM

Quote from: Turin on January 25, 2025, 04:10:51 PM

Thank you!!!! Pretty sure they are M10.

Update - found via E-bay Italia! Thank you Charles !

You're welcome. I looked through all of my stash of parts and didn't find any.