Wildguzzi.com
General Category => General Discussion => Topic started by: Turin on July 16, 2025, 01:15:19 PM
-
I'm looking to borrow (or buy) a set of lemans 1000 triples. I'm looking to have a set of reduced offset trees made for the long term, never finished project. My machinist needs something to pattern off of. The new clamps will look somewhat like this, maybe a touch fancier.
(https://i.ibb.co/7JtZJgZ0/se-triples.jpg) (https://ibb.co/7JtZJgZ0)
The pattern clamps can be junk, as I'm not putting them on a bike.
Thanks!
-
Hi [Turin] -
Can't help you with this project but I have a curious question -
Is your machinist going to map this out the traditional way, or laser scan?
Thanks, have fun -
Norman
-
The caliper brackets were 3d printed in plastic, test fit and then machined. I'm not sure on how the sausage is made.
The other stuff he's made for me...
(https://i.ibb.co/cK0WQnD9/brake-brackets.jpg) (https://ibb.co/cK0WQnD9)
(https://i.ibb.co/zTnXV2xD/fork-brace-2.jpg) (https://ibb.co/zTnXV2xD)
-
I have Curtis Harper looking. :grin: