Wildguzzi.com

General Category => General Discussion => Topic started by: travelingbyguzzi on July 21, 2025, 07:38:20 PM

Title: Norge centerstand diagram
Post by: travelingbyguzzi on July 21, 2025, 07:38:20 PM

I have lost the hardware from the left side hinge point of my centerstand. Can someone provide an exploded diagram of this?
Thanks in advance

B8ll Lovelady           IS
Eskimo Spy

Title: Re: Norge centerstand diagram
Post by: guzzisteve on July 21, 2025, 09:23:05 PM

That was an issue w/them and had a service bulletin on it to locktite the bolt. It has a big hole that a bushing/spacer sets in w/bolt in center.
I'll see if I can copy & paste from parts book.

Title: Re: Norge centerstand diagram
Post by: guzzisteve on July 21, 2025, 09:35:11 PM

(https://i.ibb.co/Cjc27F8/Norge1200-T-TL-GT-GTL-2006-PL-GB.jpg) (https://ibb.co/Cjc27F8)



3rd page down

Title: Re: Norge centerstand diagram
Post by: ridingron on July 22, 2025, 12:48:20 AM

Both sides aren't the same.

Any reasons why?

Title: Re: Norge centerstand diagram
Post by: Huzo on July 22, 2025, 06:29:07 AM

Quote from: ridingron on July 22, 2025, 12:48:20 AM

Both sides aren't the same.

Any reasons why?

Yes.
Because you hook the right side on, then fit the bolt.

Title: Re: Norge centerstand diagram
Post by: guzzisteve on July 22, 2025, 07:59:54 AM

Both sides are identical, IF you can read there are 2 of each part.

Title: Re: Norge centerstand diagram
Post by: travelingbyguzzi on July 22, 2025, 04:58:59 PM

Thanks, Steve. I figured there was a bushing in there. It took 95k m8les to work it's way out.
I am currently in the Selkirk Mountains of SE British Culumbia (it is beautiful here) and stuck in a 1/2 inch bolt, 2 washers and a nylon nut. Surprisingly, the local hardware store here only had SAE nuts and bolts.