Wildguzzi.com

General Category => General Discussion => Topic started by: bmc5733946 on August 26, 2025, 01:16:19 PM

Title: Plug cover
Post by: bmc5733946 on August 26, 2025, 01:16:19 PM

I do not have an oxygen sensor installed and would like to have a cover for the still existing plug in the wiring harness. I am certain I have seen them on other bikes or maybe cars to seal a diagnostic connector or some such. Fits over this housing and engages the retainer lock. Guzzi uses a three pin for diagnostic plug and supplies a cap. This is a four pin connector.

https://www.delcity.net/store/wire-connectors-quick-splices/te-amp-superseal-1-5mm-series-connectors/plug-housing-4-way/?srsltid=AfmBOooQghZkwj-62ymt4mIDc9fuPuX2gfMsT7fEd2QLGcUqDNlGrcS-JZw

Everything I can find is off shore and shipping is now questionable. I have temporarily filled the old sensor plug housing with silicone but that feels very temporary.

Any ideas appreciated!

Brian

Title: Re: Plug cover
Post by: guzzisteve on August 26, 2025, 02:51:24 PM

Just get the female connector & plug wire holes. Another supplier may have caps. I got mine from a Co in NJ. I had to replace the bigger ones under the tank on loom.

Title: Re: Plug cover
Post by: bmc5733946 on August 26, 2025, 03:02:43 PM

 "I have temporarily filled the old sensor plug housing with silicone but that feels very temporary."

Brian