Wildguzzi.com
General Category => General Discussion => Topic started by: Moshoeshoe on December 08, 2025, 04:23:46 PM
-
Could anyone share some advice on relocating the turn signals to accomodate the Givi luggage racks on v85? Moving them looks pretty simple, BUT ... I can't get the mud guard off to access the nuts holding the signals on. The v85 Service Manual diagram shows six screws put in horizontally from the underside, and three put in vertically, also from the underside. I've got those all out, but something is still stuck, just in front of the three vertical screws. Is there a snap or prong somewhere I'm not seeing? Or screws from the inside facing down? Don't want to break the plastic and wind up with a hole. Thanks!
-
This may not apply to your bike. Some time ago I pulled the plastic inner fender off a V7 or the like. IIRR There were screws from the top near the seat latch, under side of the fender towards the front and inside the tail light (had to remove tail light lens to get to them). Then I think I slid it back just a bit and it came off. Back on with keeping the wires in place was a bit of a pain.
Hope this helps,
Tom