Wildguzzi.com
General Category => General Discussion => Topic started by: stuv65 on January 27, 2015, 07:53:31 AM
-
I have the Guzzi part number for the UJ carrier bearing for my Le Mans Mk 5, but does anyone have the SKF part number please?
ta
stuart
-
Check out this table at Guzzitech GB: http://guzzitek.org/tableaux_guides/Roulements_Spis_Toriques_MAJ18.pdf
It cross-references many Guzzi bearing part numbers with SKF numbers.
-
Pull the bearing and look on the race for the numbers. Give these numbers to your bearing retailer and tell them you want a SKF bearing to match. If the numbers are not legable measure the OD x ID and thickness and give theses numbers to you bearing retailer.
Numbers will be something like 6206RS (60mm x 30mm x 16mm). 6206 is common within most bearing manufacturers as the "RS", It stands for "rubber seal"
While your swing arm is out also get the pivot bearing sizes and seal sizes. I can get you the 3 bearings and 2 seals for about $40 USD. Don t know what shipping would be though. Bearings are KOYO.
-
SKF 6206-2RS1
http://www.thisoldtractor.com/moto_guzzi_tonti_u-joint_carrier_bearing_cross-references.html
-
Try these fellas Stuart, I've always had good service from them.
http://simplybearings.co.uk/shop/advanced_search_result.php?keywords=6206
-
Most bearing houses would carry what you need. The number off the old bearing will work.
-
Thanks all for the useful comments.
I should have said, from the bearing I removed I could only read "GERMANY" and "S**" but nothing else.
Thanks again - ta, stuart
-
Swedish company that made the bearings in Germany.