Wildguzzi.com

General Category => General Discussion => Topic started by: Adk.IBO on April 30, 2015, 10:05:46 AM

Title: Anybody ever experiment with drilling a hole or holes in a Norge windshield?
Post by: Adk.IBO on April 30, 2015, 10:05:46 AM

Looking to get rid of or reduce buffeting. Thinking Cal-Sci effect or Gold Wing vent. Now that I think about it someone had snap vents available, I'll have to do some searching...

Title: Re: Anybody ever experiment with drilling a hole or holes in a Norge windshield?
Post by: rocker59 on April 30, 2015, 10:18:13 AM

http://rifle.com/Motorcycle-Windshields/Accessories/Air-Balance-Windshield-Vent-Kit.aspx

or

http://www.craigvetter.com/pages/online_store/Replacement_Parts/snap_vent_alert1.html

or

(http://rocker59.smugmug.com/photos/i-Nnsk4qK/0/M/i-Nnsk4qK-M.jpg)

Title: Re: Anybody ever experiment with drilling a hole or holes in a Norge windshield?
Post by: Adk.IBO on April 30, 2015, 10:30:27 AM

Thanks Rocker!

Title: Re: Anybody ever experiment with drilling a hole or holes in a Norge windshield?
Post by: canuguzzi on April 30, 2015, 12:47:15 PM

What else works? Those cable hole covers for desks. They make them in all kinds of colors including metallic. They don't open like a flip type ala Vetter but they rotate so you can adjust the air flow through them.

http://www.cableorganizer.com/round-grommets/


The Norge shield already allows quite a bit of air to flow underneath it though.