Wildguzzi.com
General Category => General Discussion => Topic started by: atavar on May 04, 2015, 09:16:45 PM
-
I am installing the light kit in my Givi top case. I would really like to find a connector pair to make an adapter instead of hacking in to the wiring harness to add a diode.
Does anyone have a dead/wrecked Norge they could cut the connector out of leaving some inches of wire for soldering to?
Alternatively do you know of part numbers and a source for the connectors?
TIA, Please IM me or reply here if you can help.
-
I think I found the connectors and pins at digikey. About $40 for enough to make two adapters. Ouch.
If I do order these would anyone else like a plug-and-play insertable (no cutting stock wires) adapter with outputs for brake, tail and brake/tail signals? Your cost would be like $20 plus shipping, actual cost, no profit.
Here is a link to what I am thinking of ordering.. http://www.digikey.com/short/7wdnm3 (http://www.digikey.com/short/7wdnm3)
-
Completely different connector. These are three pins only. I did get the ones from DigiKey and they worked great! The Givi connectors used for the installation are a PITA though, they have to be aligned perfectly.
-
Completely different connector. These are three pins only. I did get the ones from DigiKey and they worked great! The Givi connectors used for the installation are a PITA though, they have to be aligned perfectly.
I took the link off to avoid confusion that you refer to here. The OBD connector on my Norge is the same 3 pin connector as the tail light and ABS interface.
Ordered the goodies you so kindly listed from Digikey. ;-T Can't wait to hook my extra brake light!
Hunter
-
The only caution I make is to ensure you are putting the right pins in the right holes on the connectors. The pin removal tool costs more than the connectors.