Wildguzzi.com
General Category => General Discussion => Topic started by: dsrdave on June 26, 2015, 11:32:11 AM
-
I'm looking for 5 part #98326014 screws. They're used to attach the fairings on an 850 Lemans, CX100, SP1000,Monza and probably more. It's a low profile slotted screw that I seem to be having difficulty finding. Any help would be much appreciated. Thx, Dave.
-
Try putting GUin front of the number, or check here:
http://www.collmann.eu/product/index.php?produkt_id=22238.0
Good luck
-
It looks like they have it, however a lot of places show it but it's not available. If I don't find some near by I'll give them a shot. Thanks for the link !!! Dave.
-
is that for the winshield piece? were those nylon? I don't recall.
-
you could also check out McMaster Carr
-
Glad to see that someone wants to do this the right way. I went to Ace Hardware over 20 years ago and purchased small bolts, cup washers, lock washers, and nuts to mount my LM3 windshield. This is something I should look into if your quest is successful. Good luck.
-
No, these are not for the windshield. These hold the fairing to the brackets. McMaster does not have the correct ones..... Bevel Heaven has some chrome ones used on a Duc. But they are not quite correct either. And yes I believe the windshield mount screws are nylon.
-
Chris Harper told me only Nylon washers and bolts for windshield mounted to fairing so whole windshield breaks away instead of shatters into sharp pieces in a crash. Hope I never have to find out if it's true. Got some from Harper's but also available at ACE hardware.
Dave
Galveston
-
If its the same large diameter slotted head screws that were used on the LM-IV, they may be really hard to find new. I'd check with Harpers or MG classics or maybe Eish.
I lost one and ended up using a truss screw with a large washer underneath It was under the fairing so didn't really show.
-
Fastnal catalog. They can screw anything, might even be online.
-
Can you post a pic?
-
No, these are not for the windshield. These hold the fairing to the brackets. McMaster does not have the correct ones..... Bevel Heaven has some chrome ones used on a Duc. But they are not quite correct either. And yes I believe the windshield mount screws are nylon.
My bad for not looking more closely. Sad to say, but I doubt the ones mounting the fairing to the bracket are correct either. Oh well, my 3 is a keeper with over 25 years of ownership.