Wildguzzi.com
General Category => General Discussion => Topic started by: cappisj1 on August 09, 2015, 10:16:39 PM
-
My rearend is leaking (there is no good way to type that). I find it on the rim about every other time I ride it. I did have it apart to replace the clutch. The leak started about 3000 miles after putting it back together. What might I have done wrong?
-
After 3000 miles , probably nothing . Have you tried burping the bevel box ?
Dusty
-
A bit more detail would be helpful.
-
Here are two pictures. You can see the drips and runs on the rim. It doesn't seam to spay all the way around the reareend housing just dropping out the bottom on to the rim.
-
Pics aren't showing. :cry:
-
Pictures of the wheel won't do much good. A look at the pumpkin from where the wheel was will tell if it is the outer or inner seal.
-
Struggling with getting the picture up. Do you want me to take the wheel off for a picture? The pic I have shows the pumpkin from the rear where it comes together and some of the rim. Like I said it is not spraying all over. Its like it drips from the pumpkin on to the rim.
-
Unless the casting of the case is porous, (Unlikely.) there are only a few places it can leak from.
The filler, level or drain plugs, the joint between pinion carrier and swingarm or pinion carrier and box casting, the crow wheel plover plate gaskets or one of the two crown wheel carrier seals.
The plugs and pinion carrier leak points are very easy to check visually. The seals require removal of the wheel.
If the oil is dribbling down the face of the box over the crownwheel cover plate but the inside of the crownwheel carrier, (The splined bit that the wheel fits into.) is dry of oil it will be the large, visible seal in the crownwheel cover plate. If though oil is running down the inside of the crownwheel carrier it will be the inboard, smaller seal which requires disassembly of the box to get to.
Pete