Wildguzzi.com

General Category => General Discussion => Topic started by: Chuck in Indiana on August 14, 2015, 10:30:49 AM

Title: Wanted: dead V65 and later clutch plate
Post by: Chuck in Indiana on August 14, 2015, 10:30:49 AM

To make a wrench for dis assembly of the small block transmission. I'll pay shipping and beer..  :smiley:

Title: Re: Wanted: dead V65 and later clutch plate
Post by: normzone on August 14, 2015, 11:26:21 AM

Might be cheaper to by a V65... :boozing:

http://www.pizzaport.com/grog/kegs/

Title: Re: Wanted: dead V65 and later clutch plate
Post by: John A on August 14, 2015, 12:57:06 PM

If I can find it its yours, I'm still looking for that tech data I promised you, I found some of it and it's forcing me to go through stacks which is good- I wouldn't have done it otherwise. I might as well go through piles too!

Title: Re: Wanted: dead V65 and later clutch plate
Post by: Chuck in Indiana on August 14, 2015, 08:01:14 PM

Quote from: john A on August 14, 2015, 12:57:06 PM

If I can find it its yours, I'm still looking for that tech data I promised you, I found some of it and it's forcing me to go through stacks which is good- I wouldn't have done it otherwise. I might as well go through piles too!

 :smiley: :thumb: Not that I haven't done anything like that..

Title: Re: Wanted: dead V65 and later clutch plate
Post by: BMCMOTO on August 15, 2015, 04:42:59 PM

Chuck, I've got one pm me your address.  In fact I've got two, want to make me a tool too?

Brian

Title: Re: Wanted: dead V65 and later clutch plate
Post by: Chuck in Indiana on August 15, 2015, 04:59:00 PM

Quote from: bmc5733946 on August 15, 2015, 04:42:59 PM

Chuck, I've got one pm me your address.  In fact I've got two, want to make me a tool too?

Brian

Sounds like a plan. I'll send you a PM  :thumb:

Title: Re: Wanted: dead V65 and later clutch plate
Post by: John A on August 15, 2015, 07:23:59 PM

That's good, I'm still looking for mine- I put up a new building last winter so I can't find stuff anymore!

Title: Re: Wanted: dead V65 and later clutch plate
Post by: Muzz on August 15, 2015, 09:05:52 PM

I know from experience that Steamdriven's 500 Monza one does not fit the Breva.  Fortunately, Vasco DG had a clutch and sent it over.  I had a bit of pipe exactly the right size for the centre to go in and weld in place.  The blurdy great chunk of steel that is the handle is demountable in case Pete needs the action bit over in Oz.