Wildguzzi.com

General Category => General Discussion => Topic started by: nc43bsa on August 29, 2015, 01:35:35 PM

Title: part needed - rear turn signal wire boot
Post by: nc43bsa on August 29, 2015, 01:35:35 PM

My non-OEM rear turn signals have 12mm threaded stalks with 17mm nuts.  What I'm looking for is a rubber right-angle boot that would snap onto the nut and stalk and accept the tube that encloses the signal wires.

Since the signals are non-OEM, the boots don't need to be Guzzi either.

The signals are mounted on H-B mounts and the wires are out hanging in the breeze.  They don't need to be waterproof, I just want to conceal them somewhat.

Any part number suggestions?

Title: Re: part needed - rear turn signal wire boot
Post by: rodekyll on August 29, 2015, 02:12:50 PM

Get a few inches of shrink tube and roll your own.

Title: Re: part needed - rear turn signal wire boot
Post by: Antietam Classic Cycle on August 29, 2015, 02:15:49 PM

http://www.mgcycle.com/index.php?main_page=product_info&cPath=37&products_id=319

(http://www.mgcycle.com/images/atrex/12735100.jpg)

Title: Re: part needed - rear turn signal wire boot
Post by: nc43bsa on August 29, 2015, 10:42:40 PM

I believe I'll add that to my next order.  They're certainly cheap enough.  <snap suspenders>