Wildguzzi.com

General Category => General Discussion => Topic started by: solarsea on October 02, 2015, 04:38:54 PM

Title: Mount points for a leaner sidecar on second gen V7s ?
Post by: solarsea on October 02, 2015, 04:38:54 PM

It sounds like a fun and doable winter project, so what the heck. A leaner sidecar attaches to two points across the bike longitudinal axis, the front being higher so that the car itself will turn a bit while leaning.

So far so good - it appears that I can mount a brace with a ball joint/bearing on the upper two bolts that hold the frame's sections in front of the engine.

But what about the rear mount ? The cross section bellow the engine could work but I have some doubts about adding stuff beneath a stressed engine/gearbox assembly.

Hack fans, please do tell :)