Wildguzzi.com

General Category => General Discussion => Topic started by: Raimon S on October 06, 2015, 05:57:01 PM

Title: Guzzidiag connect problem
Post by: Raimon S on October 06, 2015, 05:57:01 PM

Hello, I am having trouble connecting to my '94 Cal 1100i with the KKL VAG-COM 409.1 and fiat adapter. Message to switch igniton on reverts to "ignition off" after turning key on. It shows "disconnected" at the bottom of the page. Since this is all new to me I actually considered that  progress!  Any help would be awesome. When the bike runs really badly, the throttle becomes useless so I suspect the TPS.

Title: Re: Guzzidiag connect problem
Post by: Chuck in Indiana on October 06, 2015, 06:07:28 PM

When it says to turn the key on, you have to do it without much delay. <shrug> If you've jumped through the hoops to get the ecu talking to the computer, it should work. Maybe.  :smiley:

Title: Re: Guzzidiag connect problem
Post by: rboe on October 06, 2015, 07:06:52 PM

I'm seeing the same problem (after I had a working solution). One problem; the laptop did not have the right driver and COM setup for the cable. Now I'm being advised the cable may have gone bad. Yay.  :laugh:

If you do not have the FTDI (spelling?) cable, but instead a counterfeit cable - there are lot's out there - that can cause it to not work.

So those are a few failure modes.