Wildguzzi.com

General Category => General Discussion => Topic started by: redrider on May 11, 2016, 05:46:34 PM

Title: Clutch M Cyl
Post by: redrider on May 11, 2016, 05:46:34 PM

I replaced the Brembo clutch master cylinder today; the original one had developed a lot of free travel before actuating the slave. Being me, I had to take apart the old one. Seepage past the o-ring. What puzzles me though is why there is no spring to ensure the piston retracts fully. The piston does not capture a seal or cup-the only rubber part is the o-ring in a groove machined into the mc body. Never seen such.

Title: Re: Clutch M Cyl
Post by: oldbike54 on May 11, 2016, 10:04:33 PM

 Pretty sure they rely on pressure from the other end to push the piston back .

 Dusty