Wildguzzi.com
General Category => General Discussion => Topic started by: RCBlake on May 19, 2016, 03:19:10 PM
-
Hi there,
New to Wildgoose, but not to Guzzi. I'm rebuilding my 1982 V50iii, and need the following for the left side of the engine:
-piston
-cylinder
-head
-rocker assembly
-pushrods
Anyone with a lead on them on the cheap would be appreciated.
Thanks,
Randy Blake
-
I should have all of that. 816.697.3411
-
But he said
on the cheap
Curtiss.. :grin: :boozing:
-
Dude- if you don't know Curtis yet, you just got introduced to one of the worst "enablers" in the Guzzi world. Damn, the factory contacts Harpers for stuff they run out of. :thumb:
-
But he said Curtiss.. :grin: :boozing:
Cheap is definitely relative.
-
Thanks Curtis,
I call Harper's when I need new parts. i'm looking for salvage in this case though.
-
Thanks Curtis,
I call Harper's when I need new parts. i'm looking for salvage in this case though.
Call us now, I have tons of properly experienced parts. I can most likely just pull the entire setup off of a motor and get you going.
-
I can see now an annual pilgrimage to Harper's should be added to my schedule... :thumb:
-
Hey Randy, welcome to the madness.
-
I have the following MK2 stuff I'll sell cheap
Pistons
Rods
Cylinders
Block
Oil pan
Parts transmission
+ so other stuff I'm sure I forgetting
and by cheap I mean cheap.
-
Thanks Perrazzimix,
Do you have a head for the left side, and is it the same as the mk3? if so how much for it with valve assembly, rockers, and pushrods? feel free to txt or call 216-409-7660.
Thanks!
-
2 and 3 are quite a bit different