Wildguzzi.com
General Category => General Discussion => Topic started by: boatdetective on May 30, 2016, 06:43:49 PM
-
Like the title suggests, I went through all the steps, connected, guzzidiag reading properly. I went to actors, chose "TPS rest", hit start, and got "TPS rest error". Sorry if this has been discussed before, but since there is no search function on the forum, I'm forced to ask it again.
Thank you!
-
Never had that problem? I'd try disconnecting, closing everything down and then firing it up and trying again. You have selected the right machine/ECU?
-
Pete- I know, it is odd. I've got the ECU all set up proper and have reset the TPS on this bike in the past.
BTW, while I'm in there, any thoughts on CO trim? mine is at 3. I have a Mistral can with the db killer in. I'm running a custom map- don't know if it's beetle's or Molly's.
-
That happened to me once. I exited GuzziDiag and tried again and it worked. No explanation.
If the bike is running great at CO=3, then leave it. That's all I have to say about that.
-
Like the title suggests, I went through all the steps, connected, guzzidiag reading properly. I went to actors, chose "TPS rest", hit start, and got "TPS rest error". Sorry if this has been discussed before, but since there is no search function on the forum, I'm forced to ask it again.
Thank you!
Start over with guzzidiag, ignition on, engine not running
-
Have you checked for errors? I have seen reset issues if there are errors that need cleared.
-
but since there is no search function on the forum, I'm forced to ask it again.
Upper right corner..
-
If there are errors, sometimes it prevents from doing settings. Like with the 15m is idle tps value is way to low it won't let you set CO.