Wildguzzi.com

General Category => General Discussion => Topic started by: cwiseman on July 11, 2016, 09:25:15 PM

Title: 72 Eldo, mounting a rear fender bumper
Post by: cwiseman on July 11, 2016, 09:25:15 PM

I finally found a DB rear fender bumper, it came off a T-3 but figured I might get lucky and it be the same for the Eldo? Anyways I see two diffrent ways of mounting it and have no clue weather of them are correct, sure I can make it work but was hoping to get some advice as to the correct way of mounting it, or some pictures of one mounted showing how it's attached

Title: Re: 72 Eldo, mounting a rear fender bumper
Post by: cwiseman on July 12, 2016, 03:45:22 PM

Biggest question, does the top mounting point of the bumper/chrome trim mount to the fender or the frame. If it's the frame is a spacer needed?

Title: Re: 72 Eldo, mounting a rear fender bumper
Post by: Tom H on July 12, 2016, 04:34:33 PM

Looking at a picture of one. It looks like the bottom mount goes to the license plate/ turn signal chrome mount holes in the fender and the top tabs go to the tabs on the frame.

I've never had DB parts, so I could be wrong.

Tom