Wildguzzi.com
General Category => General Discussion => Topic started by: PJPR01 on August 04, 2016, 03:45:34 PM
-
Is there anyway to use GuzziDiag to make the illumination on the Norge Speedo much brighter, or even possible to change the color at all, or this light soldered onto the circuit board and impossible to get to?
Anyone done any modifications to the illumination for their Norge?
-
Is it currently an LED?
-
Go into the menu and pick 'Settings'. The dash has three levels of brightness.
-
Go into the menu and pick 'Settings'. The dash has three levels of brightness.
Thanks Pete...I should have clarified further in my initial post. I've got it on the brightest setting, was hoping to go past the factory settings if there was any way to do so...realize the chances are slim, but figured there might be a chance somehow with GuzziDiag software.
-
I used rubber washers and longer screws on the top of mine to tip it toward me. Makes for a lot less glare, reads somewhat better.
-
I used rubber washers and longer screws on the top of mine to tip it toward me. Makes for a lot less glare, reads somewhat better.
Very innovative...hadn't thought of that! Thank you!
-
Thanks Pete...I should have clarified further in my initial post. I've got it on the brightest setting, was hoping to go past the factory settings if there was any way to do so...realize the chances are slim, but figured there might be a chance somehow with GuzziDiag software.
Time to visit your eye doctor, old man! :evil:
-
:) I got the idea because the LED lights I installed in the garage have 5 settings of dim, and the Norge only has 3, so I figured there must be a way to get the dash a bit brighter during the day. Admittedly the angling solution sounds like the best one here...at night it's perfectly fine...
Now I wonder if I could find a Huckleberry light to replace the red one! :)
-
A piece of tape solves the problem.. !
-
Helpful...very helpful!! Ok...back to the garage to keep getting body parts off to take to the painter soon...