Wildguzzi.com

General Category => General Discussion => Topic started by: Tobit on September 28, 2016, 09:25:28 AM

Title: SD-Tec Clutch Kit? Anyone running this?
Post by: Tobit on September 28, 2016, 09:25:28 AM

Finally going to replace the clutch and hub in the '86 LeMans.  Going to a deep spline setup of course.  MG Cycles is selling teh SD-Tec kit with both friction plates, intermediate plate and hub. 

Is anyone here using this product or have any prior experience with it?

Tobit

Title: Re: SD-Tec Clutch Kit? Anyone running this?
Post by: Antietam Classic Cycle on September 28, 2016, 09:40:40 AM

I don't buy the kit, but usually buy the pieces separately. The SD-TEC friction plates are arguably the best available right now, but do seem to be slightly thicker than standard, so may require a slightly longer clutch pushrod.

I like the "new and improved" intermediate plate over the cheaper version they have been selling.

The new "shiny" springs have the same spring pressure as the original "red paint" springs. 

Title: Re: SD-Tec Clutch Kit? Anyone running this?
Post by: Tobit on September 28, 2016, 10:32:12 AM

Thanks!

Tobit