Wildguzzi.com
General Category => General Discussion => Topic started by: M0T0Geezer on October 27, 2016, 05:34:51 PM
-
Got a 12 year old valve cover gasket on my '04 Breva 750.
Some of it fell apart and the rest is stuck on like welded steel. Cleaned it up best I could but the new gasket leakes a lot.
Any one know of magic solvent or special technique to be rid of all the old ?
"Search" function here is missing.
-
Search works fine, but I use Perma Tex gasket remover in a rattle can. Spray it on, let it soak a while, scrape it off. Be aware that it is also a quite effective paint remover.. :shocked: so don't get it anywhere you don't want it.
-
Angle grinder with a medium scotch brite roloc disk.
-
"Search" function here is missing.
it's in the far upper right corner.
-
The "Search" function window can be elusive . Click on the multicolored Wild Guzzi . com window top right and then click on General Discussion, Search should appear .
Dusty
-
You can also use "Aircraft Remover" paint remover. I use the stuff in the quart can that you brush on and use an acid brush to apply it.
(http://farm4.staticflickr.com/3198/3142032646_2584d873cb.jpg)
-
I have just replaced the old green gaskets with the black ones. I used a mix of Acetone and acrylic spray thinners, a cloth and a very strong thumbnail. Took a bit of effort but the surfaces cleaned up nicely. New ones don't leak.
-
Aircraft remover.....leaves the paint.