Wildguzzi.com

General Category => General Discussion => Topic started by: chrisk on December 02, 2016, 03:27:22 AM

Title: V65 regulator/rectifier - connection to loom Question
Post by: chrisk on December 02, 2016, 03:27:22 AM

Hi, just reconnected this after removing the air box, are the two black wires at the top the right way around?

Thanks


(http://thumb.ibb.co/ejz0RF/IMG_2620.jpg) (http://ibb.co/ejz0RF)

imgbb (http://imgbb.com/)

Title: Re: V65 regulator/rectifier - connection to loom Question
Post by: pat80flh on December 02, 2016, 04:37:57 AM

Looks the same as mine, the top wire with the 90 degree spade connector on mine is a different color wire, blue I think.

Does it charge?

 Are you putting pod filters on?

Title: Re: V65 regulator/rectifier - connection to loom Question
Post by: chrisk on December 02, 2016, 05:43:00 AM

Hi, haven't started it yet, but I'll assume it's okay for now - thanks.

I was very close to fitting pods as the air box is such a f*r to fit and needed a few repairs but after much patience I got it back in there. Not a job if your in a rush...

Title: Re: V65 regulator/rectifier - connection to loom Question
Post by: Groover on December 02, 2016, 07:18:14 AM

If it doesn't charge, swap the red and the white-ish one (the one next to it), but otherwise I'd say it looks stock and correct. The only reason I say possible swap the two is because my G5 has the red on the end terminal (where that white one is) and has a dark blue where that red is now. The blue goes to the charging lamp on the dash and in my case and needs to be in place for the charging system to work, and I think that charging system works the same way.