Wildguzzi.com

General Category => General Discussion => Topic started by: rodekyll on January 18, 2017, 12:52:05 AM

Title: need length of convert hex drive piece
Post by: rodekyll on January 18, 2017, 12:52:05 AM

Could someone put a caliper to a Convert atf pump drivepiece -- that 6mm hex?  IIRC it's 28mm, but I'd like to be sure before I cut it.

Thanks

Title: Re: need length of convert hex drive piece
Post by: pehayes on January 18, 2017, 11:33:05 AM

I don't know.  Odd that no response has arrived.  There is a yahoo forum specific to Convert.  MGconvert@yahoogroups.com  Might get more traffic asking there.

Patrick Hayes
Fremont CA

Title: Re: need length of convert hex drive piece
Post by: rodekyll on January 18, 2017, 12:23:42 PM

It's one of those things I should just "know", but I had the hydro can EDM drilled deeper than stock and use a 35mm length of drive piece. So 35mm is stuck in my head.  I broke a timing cover once by using too long a piece.  Trying to avoid that this time.

Title: Re: need length of convert hex drive piece
Post by: pehayes on January 18, 2017, 01:27:06 PM

I posted the question for you at the Convert forum and got this response.

"I have two “OEM” Guzzi hex drive pieces, they are both 31.5mm in length I also have a Harper’s replacement which is 32mm long.
Hope this helps, Wayne"

Patrick Hayes
Fremont CA

Title: Re: need length of convert hex drive piece
Post by: rodekyll on January 18, 2017, 03:32:50 PM

Thanks!  I can work with that.   :smiley: