Wildguzzi.com

General Category => General Discussion => Topic started by: bikeridertim on February 12, 2017, 07:22:22 PM

Title: 1999 Moto Guzzi clutch lever bushing
Post by: bikeridertim on February 12, 2017, 07:22:22 PM

Dose anybody have a part number for a 1999 Moto Guzzi EV11 clutch lever bushing? I only got 146,000 out of the original!  :grin:
OR can anybody explain the extra lip?? (makes it look like a tophat) I am sure I can make one, but I'm confused as to the lip??   :huh: :huh:
Thanks in advance!
Bikeridertim

Title: Re: 1999 Moto Guzzi clutch lever bushing
Post by: fotoguzzi on February 12, 2017, 07:37:32 PM

not sure what bushing you are asking about, here's parts book for a 2002 big block probably the same,

http://www.thisoldtractor.com/mg_manuals/spare_parts_catalog_california_aluminum_special_sport.pdf

you might want to browse around here for other manuals,

http://www.thisoldtractor.com/moto_guzzi_tonti_spare_parts_catalogs___exploded_parts_diagrams___parts_fiche.html

Title: Re: 1999 Moto Guzzi clutch lever bushing
Post by: bikeridertim on February 12, 2017, 07:57:22 PM

I'm looking for the hand lever bushing.........
None of the parts books show just the bushing.
.

Title: Re: 1999 Moto Guzzi clutch lever bushing
Post by: LowRyter on February 12, 2017, 08:11:36 PM

http://www.harpermoto.com/parts-by-motorcycle/1990-2000-moto-guzzi-motorcycles/california-ev-v11-ev-usa-1100-1997-2000/handlebar-controls-en-california-1100-ev.html

Title: Re: 1999 Moto Guzzi clutch lever bushing
Post by: sib on February 13, 2017, 07:06:14 AM

This may or not be helpful:  the black plastic bushing used in the later V7s doesn't seem to have its own part number and isn't even shown in the parts manuals.  However, I believe it is Domino/Tommaselli part 97.1662.  It is usually supplied with the clutch lever if you order part GU30605700 (you can also buy the lever alone as part GU32605511 or the whole lever assembly as part GU32605510).  Good luck.

Title: Re: 1999 Moto Guzzi clutch lever bushing
Post by: twhitaker on February 13, 2017, 04:27:18 PM

I had Lee Bruns make me one out of bronze for about 10 bucks 15 years ago. I'll see if I can find the drawing at work tomorrow.

Title: Re: 1999 Moto Guzzi clutch lever bushing
Post by: Gootsz on February 14, 2017, 10:31:58 AM

I just went to Ace hardware, got a nylon bushing. pressed it into the lever and drilled to fit. @2.00

Micky

Title: Re: 1999 Moto Guzzi clutch lever bushing
Post by: bikeridertim on February 14, 2017, 04:51:48 PM

Thanks guys Im just going to make one