Wildguzzi.com

General Category => General Discussion => Topic started by: twowings on August 21, 2017, 07:50:02 PM

Title: I need help..."Yes, we KNEW that!"
Post by: twowings on August 21, 2017, 07:50:02 PM

(http://thumb.ibb.co/jh1xsQ/20170817_155744_001.jpg) (http://ibb.co/jh1xsQ)


See the aluminum-colored small conical piece on the end of the LH grip?  I need one of those...looked thru parts catalogs and can't find the same thing so I'm guessing it was unique to the Stelvio handguard kit? I can take a close-up solo shot if necessary...would love to get another one to replace one that was lost somewhere between Datil and home...thanks in advance!
Title: Re: I need help..."Yes, we KNEW that!"
Post by: lorazepam on August 21, 2017, 08:00:43 PM
I am sure there is a part number for it. Should use the parts look up on one of the vendors sites. They are pretty handy.
Title: Re: I need help..."Yes, we KNEW that!"
Post by: pyoungbl on August 21, 2017, 08:19:59 PM
You are correct, the part does not show up on the AF1 Racing parts list.  I lost the same part on my Stelvio so I turned a new one on the lathe.  That does not help you much but maybe you have a machinist friend who can make one for you.   
Title: Re: I need help..."Yes, we KNEW that!"
Post by: guzzisteve on August 21, 2017, 09:31:36 PM
AP8121819       says it's a washer
Title: Re: I need help..."Yes, we KNEW that!"
Post by: twowings on August 21, 2017, 09:43:19 PM
Quote from: guzzisteve on August 21, 2017, 09:31:36 PM
AP8121819       says it's a washer

Thank you again!! That's it...
Title: Re: I need help..."Yes, we KNEW that!"
Post by: ITSec on August 21, 2017, 11:00:30 PM
Quote from: guzzisteve on August 21, 2017, 09:31:36 PM
AP8121819       says it's a washer

So, when Guzzi says "Special Parts", it means all the NTX accessory package stuff! Good detective work there, Steve!
Title: Re: I need help..."Yes, we KNEW that!"
Post by: BAT 11 on August 22, 2017, 01:24:10 AM
lost mine on right returning from ACT. temp fix with insulation tape,then drilled a Aussie gold coin on both sides  to match and slid a cutoff tubeless valve base i found in plenty outside the tyre fitters over the bolt head,very unique! works a treat.