Wildguzzi.com

General Category => General Discussion => Topic started by: Saulguzzi on May 22, 2018, 11:05:59 AM

Title: bar ends for V7 iii
Post by: Saulguzzi on May 22, 2018, 11:05:59 AM

I've been searching for a more affordable bar end solution for my v7 iii but for the past 2 products I've purchased there were gaps or fitment issues.

What kind of bar end mirror solutions do you recommend?

Title: Re: bar ends for V7 iii
Post by: Toecutter on May 22, 2018, 11:32:56 AM

CRG. Stay where you put them, don't vibrate as bad as the stock mirrors. I love 'em.

Title: Re: bar ends for V7 iii
Post by: Diploman on May 22, 2018, 11:54:50 AM

 :1: CRG.  Best on the market now.

Title: Re: bar ends for V7 iii
Post by: Guzzi Gal on May 22, 2018, 01:46:44 PM

Welcome to WG Saulguzzi!  :bike-037:

Title: Re: bar ends for V7 iii
Post by: Saulguzzi on May 22, 2018, 02:44:24 PM

Quote from: Guzzi Gal on May 22, 2018, 01:46:44 PM

Welcome to WG Saulguzzi!  :bike-037:

thanks!

did you guys have to get milled ends to have the crg's clip in flush?

Title: Re: bar ends for V7 iii
Post by: Toecutter on May 22, 2018, 03:01:26 PM

No. If anything, one of them was "too" flush, and I had to trim the rubber a bit so it didn't "drag" the throttle.

Title: Re: bar ends for V7 iii
Post by: malik on May 22, 2018, 03:19:25 PM

Yes, but they were a batch made up for Corsa in the UK (since departed) with a groove for the CRG bar end mirrors (& knock offs). Very smart, but no photo - I'm still on the road. For cheap, check out the stock Royal Enfield bar ends - a big heavy lump with the same 8mm hole for the screw.

Title: Re: bar ends for V7 iii
Post by: Toecutter on May 22, 2018, 03:52:29 PM

Oh wait... sorry, I misunderstood. I replaced the stock bar ends with the milled bar ends for the CRG. They simply thread in and replace the stockers, and then the mirrors clamp into the groove on the bar end.

...did I understand this right, this time? I'm unsure.