Wildguzzi.com

General Category => General Discussion => Topic started by: Neil on June 01, 2018, 07:59:00 PM

Title: Breva 1100 Torque spec- wheel shaft clamp screws?
Post by: Neil on June 01, 2018, 07:59:00 PM: As the title says, I need the torque numbers for the four allen screws at the bottom of the forks that hold the wheel shaft (axle) in place. Not listed in my copy of the service manual. Thanks in advance.
Title: Re: Breva 1100 Torque spec- wheel shaft clamp screws?
Post by: rodekyll on June 01, 2018, 08:20:59 PM: They are pinch bolts and hold under even tension. Snug them evenly by tightening one then the other and back until they both feel uniformly tight. 8-10 pounds/ft is probably good as long as they are the same. If they are not even they will unscrew.
Title: Re: Breva 1100 Torque spec- wheel shaft clamp screws?
Post by: guzzisteve on June 01, 2018, 08:34:54 PM: 7 ftlbs max if a 6mm screw. May be the same as 1200 2V Sport or Norge.
Title: Re: Breva 1100 Torque spec- wheel shaft clamp screws?
Post by: rodekyll on June 01, 2018, 08:41:41 PM: I'll go with that. Heavy torque isn't needed. Even torque is.
Title: Re: Breva 1100 Torque spec- wheel shaft clamp screws?
Post by: guzzisteve on June 01, 2018, 08:43:37 PM: Yes, same as Norge Fork Hub Closing--10nm looked it up that quick
Title: Re: Breva 1100 Torque spec- wheel shaft clamp screws?
Post by: GuzziNZ on June 01, 2018, 11:38:20 PM: 10 Nm. No more !
Title: Re: Breva 1100 Torque spec- wheel shaft clamp screws?
Post by: Neil on June 02, 2018, 10:46:23 AM: Thanks all,
will check them tonight after work.
Title: Re: Breva 1100 Torque spec- wheel shaft clamp screws?
Post by: Wayne Orwig on June 02, 2018, 12:14:33 PM: Quote from: Neil on June 01, 2018, 07:59:00 PM
As the title says, I need the torque numbers for the four allen screws at the bottom of the forks that hold the wheel shaft (axle) in place. Not listed in my copy of the service manual. Thanks in advance.

Four?

What bike is this? Most do not have pinch bolts on the axle nut side.