Wildguzzi.com

General Category => General Discussion => Topic started by: chipdude on July 07, 2018, 01:04:13 PM

Title: 2011 Stelvio oil leak
Post by: chipdude on July 07, 2018, 01:04:13 PM

I noticed a drop or two of oil on pipe of Stelvio.
Looking closer found where oil had blown or dripped
On front and side of left hand cylinder. Small slow leak as I can’t tell that oil level is any lower in crankcase. 22,000 Miles hasn’t been rollerized yet. Could this be the 2 I rings on the plug tubes or should I dig deeper. Any suggestions on how to procede
(https://thumb.ibb.co/mah1hT/62_F931_F1_F8_C6_43_AB_86_E0_B8_BFFBE574_E1.jpg) (https://ibb.co/mah1hT)

(https://thumb.ibb.co/mcn1hT/47_DBEAC0_6_F54_4_A1_B_B778_90_E0_C7_D0_D3_F3.jpg) (https://ibb.co/mcn1hT)

Title: Re: 2011 Stelvio oil leak
Post by: guzzisteve on July 07, 2018, 02:43:41 PM

Cam sensor, oil pressure  sender are in front of LH cyl. I also fixed oil cooler leaks.

Title: Re: 2011 Stelvio oil leak
Post by: pete roper on July 07, 2018, 09:36:05 PM

On the 8V the oil pressure sensor is at the bottom of the valley almost central. Most likely guess would be a cracked breather pipe but the only way to know for sure is to roll up yer sleeves and chase it down.

Pete

Title: Re: 2011 Stelvio oil leak
Post by: chipdude on July 08, 2018, 09:47:15 AM

Steve and Pete
Thank you for your time and replies.
Will start chasing down these leads