Wildguzzi.com

General Category => General Discussion => Topic started by: BSABEN on October 06, 2018, 09:43:53 AM

Title: Eldo fork rebuild - shims
Post by: BSABEN on October 06, 2018, 09:43:53 AM

I am rebuilding my drum brake Eldo forks. There are shims above the upper slider bushings. I can't figure out what measurement these shims are intended to equal. I assume they are to even the overall length but what is to be measured?

I want to have this shimmed correctly but i have no idea what to measure / shim for!

Title: Re: Eldo fork rebuild - shims
Post by: guzzisteve on October 06, 2018, 10:04:33 AM

I think that is shimmed to keep travel of the bush to a minimum when tube goes through, less wear.