« previous next »
Pages: [1]   Go Down

Author Topic: Rotor Glaze  (Read 1079 times)

Offline Diploman

  • "The future just ain't what it used to be." Yogi
  • Gaggle Hero
  • *****
  • Posts: 504
  • Location: Murrysville PA
Rotor Glaze
« on: May 12, 2019, 05:54:41 PM »
Hi All,

I would like to know your recommended method/technique for removing glaze from a brake rotor.  Thanks.
Logged
1980 V50 II, lightly cafe'd, much modernized
1983 SP 1000 NT (Under Upgrade/Modification)
2015 KTM 390 Duke

Offline RinkRat II

  • Gaggle Hero
  • *****
  • *
  • *
  • *
  • *
  • *
  • Posts: 2294
  • Lake Powell AZ
Re: Rotor Glaze
« Reply #1 on: May 12, 2019, 07:00:18 PM »

 I've used a 90 degree air grinder with Scotch Roloc pads 120 grit or finer with good success.  I've also chucked in my lathe jusy to rotate them while deglazing.

     Paul B :boozing:
Logged
A Miller in the hand is worth two in the fridge.

Online Wayne Orwig

  • Gaggle Hero
  • *****
  • *
  • *
  • Posts: 14140
    • Hog Mountain weather
  • Location: Hog Mountain
Re: Rotor Glaze
« Reply #2 on: May 12, 2019, 08:22:21 PM »
Quote from: RinkRat II on May 12, 2019, 07:00:18 PM
I've used a 90 degree air grinder with Scotch Roloc pads 120 grit or finer with good success. 

This is what I use for brake rotors and clutch flywheels. With a light grit it is great for removing gasket material.
Logged
Good judgement comes from experience.
And experience. That comes from poor judgement.
Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here
Pages: [1]   Go Up
« previous next »
 

Check out the official Wildguzzi Amazon Affiliate Storefront.
Proceeds go back into the forum.
If you need to buy it anyway, use the affiliate link to help the forum.
Advertise Here