Author Topic: The right kit?  (Read 950 times)

Offline wymple

  • Gaggle Hero
  • *****
  • Posts: 1178
  • Location: SE Iowa
The right kit?
« on: July 31, 2020, 07:28:00 PM »
https://www.ebay.com/itm/Moto-Guzzi-Rear-Master-Cylinder-Rebuild-Kit-15mm-Brembo-round-850-1000-1765-9350/183850188490?hash=item2ace533eca:g:FaIAAOxyoA1RTO-z

Would this be the correct kit to rebuild the rear master cylinder on my 84, Cal 2?  I have no air in the system & the brake pedal can be pushed clean down to the floorboards without a lot of braking.
No trees were harmed by the conveyance of this message, but a lot of electrons were seriously disturbed.

Offline guzzisteve

  • Gaggle Hero
  • *****
  • Posts: 12931
  • "Just Ride It"
Re: The right kit?
« Reply #1 on: July 31, 2020, 07:53:03 PM »
That's same one I got to do my Cal2 but from MG. All good.
"Pray through Carlo & your bike shall be healed"
Location: Planet Earth

Offline wymple

  • Gaggle Hero
  • *****
  • Posts: 1178
  • Location: SE Iowa
Re: The right kit?
« Reply #2 on: July 31, 2020, 08:30:43 PM »
Thank you :bow:
No trees were harmed by the conveyance of this message, but a lot of electrons were seriously disturbed.

Offline Antietam Classic Cycle

  • Gaggle Hero
  • *****
  • Posts: 15090
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Charlie

Offline jazzamoto

  • Gaggle Mentor
  • ****
  • Posts: 388
Re: The right kit?
« Reply #4 on: July 31, 2020, 09:02:29 PM »
According to MG Cycles listing for that part number it's the correct kit. But you should give them a call to verify it.

https://www.mgcycle.com/index.php?main_page=product_info&cPath=110_112&products_id=753&zenid=526bf7db52749de03b888efb4e67d62c
Richmond, CA
'78 Le Mans I
2021 Honda NC 750x DCT
"JAZZAMOTO  predicted it!"

 

20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here