Questions

[keuka4884]

1. Arctic Fox, where did you get that Moto Guzzi bottle holder? very cool. Lots of generics out there but I cannot find a Guzzi labeled one.

2. For Moto and anyone else who has upgraded a T3 dash to the one with turn signal indicators. The "standard light sockets will not fit the upgraded dash. Too big. Am I missing something here? If smaller ones are required, where did you get them? As others have noted, it is about impossible to see the neutral light on the original dash!

[Antietam Classic Cycle]

I think the bulb holders are the same as Convert ones. If so, I may have some to spare.
https://www.ebay.com/itm/Moto-Guzzi-Benelli-GU14768651-Gluehlampenfassung-Lampholder-1-2-Watt-MG-NML-NOS-/372671227874

Not a T3 dash, but similar... On my V50 III, I replaced all of the warning light bulbs with LEDs. Much brighter and I can actually see them in direct sunlight! Use an LED the same color as the lens.
https://www.superbrightleds.com/moreinfo/miniature-and-subminiature-bulbs/74-led-bulb-3-smd-led-miniature-wedge-retrofit-car/228/1069/

If you replace the charge warning bulb and still have the original Bosch charging system, you'll need to add a resistor. Greg Bender offers a ready made "bootstrap harness" for this purpose.

[twowheeladdict]

1. Arctic Fox, where did you get that Moto Guzzi bottle holder? very cool. Lots of generics out there but I cannot find a Guzzi labeled one.

http://wildguzzi.com/

[keuka4884]

Charlie, thanks for that info. I would need 5 if you have them. I will not be using the bottom brake reservoir light. I do have the LED's you recommended.

Two wheel addict - I do not see any bottle holder on the WG site. What am I doing wrong? 

[keuka4884]

Oops. I forgot the turn signal indicators. Make that 7 Charlie if you have them.

[Antietam Classic Cycle]

Oops. I forgot the turn signal indicators. Make that 7 Charlie if you have them.

I'll see what I can find. EDIT: Found. Sent you a PM.